OK Jim , I hope this helps with the inspiration , despite progress being desperately slow , things are gradually happening.
One of my difficulties has been the weight of the nissan stuff, I'm not set up to handle it and the process of doing so has been a challenge.
However, we persevere ............
So the nissan engine mounts and chassis cross member were pulled from the truck and cut/stripped and modified to fit inside the Bedford chassis rails. These are a few pics showing stages of development.
Starting with basic fill in the box bit
then stuff got added till there was enough there to hang the engine off. So this bit goes inside the chassis
Actually , this engine is cradled not hung, so this bit attaches to the one above.
Up front , a piece of the nissan rear cradle is used to fill the chassis and attach the nissan mount to. This is the drivers side , the floor has also been cut and boxed for alternator clearance.
Passenger side , floor again cut (for fuel filter access) and a piece added inside chassis rail for the front engine mount.
![Image](http://i46.tinypic.com/34etjky.jpg)